Advanced Optical Fiber Cleaver CT-101

The CT52 is designed for cleaving silica fiber with 125μm cladding diameter, specially for its short length cleaving capability. Minimum 3mm cleave is possible by up to 900μm fiber coating, while the coating to be clamped.

Nyfors product. The AutoCoater 2 SC™ is used to restore the protective coating on acrylate coated optical fibers in high strength applications. It is fully automatic, allowing for operator skill independent operation in factory environments with high cost and productivity advantages. This modified version of the automatic AutoCoater 2™ is equipped with special clamps for recoating applications where only short lengths of fiber are available. A narrower positioning and shorter distance between the fiber clamps than in the standard version enables clamping and recoating of fibers as short as 124 mm without reducing the recoat length itself.

The Fiber holder FH-40-LT900 is exclusively designed for holding loose tube buffered fiber by Fujikura's fusion splicer,FSM-100 series, FSM-45 series, FSM-40F and FSM-40PM. The FH-40-LT900 holds the loose tube bufferd fiber by tightening a screw in the lid. The FH-40-LT900 is supplied with a pair.

Nyfors product. The AutoCleaver S1™ senses the edge of the coating to automatically adjust the bare fiber length after cleaving. This feature is valuable when a specific and accurate bare fiber length is required. The requested bare fiber length is specified by the customer at order and can be fine tuned by software between 0 and 500 μm.