Sinyal ve Kontrol Kabloları
_4f0de13d-6191-4f2b-8da7-4d4706281433.png){kind=icon}
Çinko / Zn
Kurşun / Pb
Fiber Ek Cihazı ve İlgili Ürünler
Nyfors AutoCoater 2 SC
Ürün Kodu SD5WET
Nyfors product. The AutoCoater 2 SC™ is used to restore the protective coating on acrylate coated optical fibers in high strength applications. It is fully automatic, allowing for operator skill independent operation in factory environments with high cost and productivity advantages. This modified version of the automatic AutoCoater 2™ is equipped with special clamps for recoating applications where only short lengths of fiber are available. A narrower positioning and shorter distance between the fiber clamps than in the standard version enables clamping and recoating of fibers as short as 124 mm without reducing the recoat length itself.
- Automatic and operator skill independent
- Short cycle time
- Special fiber clamps for recoating with short fiber lengths
- Easy mold exchange and replacement
- Handles most fiber dimensions with custom molds available
- Uniform diameter, overcoating and undersize recoating capability
- Short curing times
- High and low-index recoating
- No need for compressed air or vacuum
Specification Sheet
The FST-12 is a tool to quickly split a 12-fiber ribbon into individual fibers or sub-groups with separation ratio from 1:11 to 6:6.
Ürün Başarıyla Sepete Eklendi
HTS-12 is designed for stripping single count of silica optical fiber by keeping the stripped fiber's glass surface free from any physical contact. In order to achieve the above condition, the HTS-12 has a precise linear slide base for stripping action. The fiber is not scuffed by the blade or any other materials when being stripped. The HTS-12 is equipped with a heater to soften the fiber coating. The HTS-12 accepts the FH-40 series and FH-100 series Fiber Holder System
Ürün Başarıyla Sepete Eklendi
Nyfors product. The Auto Cleaver is designed for cleaving silica fiber with 80 to 230μm cladding diameter.
Ürün Başarıyla Sepete Eklendi
The CleaveMeter 3DTM is a phase-shifting Michelson interferometer for non-contact end-face inspection of cleaved and polished optical fibers with cladding diameters up to 1200 μm. Designed for both production and research applications, this comprehensive fiber optic testing system combines full resolution, three-dimensional surface topography reconstruction and mapping with automated, operator independent measurements of cleave angle and surface flatness in a small, lightweight benchtop unit.
_927163e5-d1b4-4309-8b9b-aac7fc87445d.png)
_5df15f60-a573-4570-87b1-b68674f7700c.png)
